Uni-Mix for Cedarapids®

Kenco Engineering offers two styles of Uni-Mix conversions for Cedarapids® pugmills.

Bolt-on Shanks

Kenco Engineering's exclusive Uni-Mix System easily converts Cedarapids® pugmills to bolt-on style shanks. Just cut down the original round weld-in shanks to a stub. Then position new cast Kenco Uni-Shanks over the stubs and tighten the bolt, locking them in place on the pugmill shaft. Product literature (PDF).

​​​​​​​See detailed installation instructions.
Bolt-On ShanksBolt-On Shanks
Weld-In ShanksWeld-In Shanks

Weld-in Shanks

Kenco Engineering one-piece Uni-Tips offer greatly simplified installation compared to two-piece OEM style tips. Kenco weld-in Uni-Mix System for Cedarapids® pugmills just requires a one-time conversion shaft. From then on standard stock Kenco Uni-Tips and Uni-Shrouds can be used in the pugmill. Product literature (PDF).

Features and Benefits:

  • One-piece Uni-Mix Tip greatly simplifies installation
  • Uni-Tips are pre-set at 45 degree angle; no alignment required
  • Easily removed when replacing liners or making repairs
  • Kenco Shafts are protected from wear by Uni-Shrouds
  • Uni-Tips can be changed in less than 5 minutes with just a sledge hammer (or air hammer) and punch
  • Wedge shaped Uni-Shrouds slice through the mix with less drag, longer wearlife
  • Uni-Tips cast from Kenco Alloy-K (550 Brinell hardness) provide significantly longer wearlife